Raven Viper Pro update NFG

[furrowtickler]

Will not look at another, but JMO

[Guest]

Case, are the fence row nozzles configured to be contolled by accuboom(if that's even possible)(included in the outer boom tip sections) with manual over-ride or only ever manually controlled?

If you add them to sprayer width it makes it wider and then guidance leaves a strip so just control them manually for spraying around field edges

[Guest]

My fence row nozzles are setup in the viper pro. However I deselect them when starting up that way you retain o ly manual control over them


1184h rogator

Mine are deselected also i think i will check It says when starting a job it will control the 7 sections and not femce row nozzles. Yours doesnt stop pump if you leave them on when your master is on but accuboom has booms all off ? Thats when this one stops pump

[furrowtickler]

120 ft ?

[Guest]

120 ft ?

No just a little one RG700, 90 ft

[furrowtickler]

Oohhhhh.

[Klause]

120 ft ?

Yes. 120

[Klause]

Mine are deselected also i think i will check It says when starting a job it will control the 7 sections and not femce row nozzles. Yours doesnt stop pump if you leave them on when your master is on but accuboom has booms all off ? Thats when this one stops pump

There's an option in the configuration for minimum pwm. I have it set so pump always runs for agitation. I'll check. I believe it's set to min 110

[Guest]

There's an option in the configuration for minimum pwm. I have it set so pump always runs for agitation. I'll check. I believe it's set to min 110

Im at 150. That gives me min 35psi with yellow tips but stil shuts off if it thinks it should be spraying out fence rows but cant cause accuboom has end sections off

[Klause]

Im at 150. That gives me min 35psi with yellow tips but stil shuts off if it thinks it should be spraying out fence rows but cant cause accuboom has end sections off

Are your fence row nozzles plumbed to the boom sections or a separate line to feed them?