• You will need to login or register before you can post a message. If you already have an Agriville account login by clicking the login icon on the top right corner of the page. If you are a new user you will need to Register.

Norac Depth Control

Collapse
X
Collapse
 
  • Time
  • Show
Clear All
new posts
  • FarmerMo
    Junior Member
    • Feb 2008
    • 1
    #1

    Norac Depth Control

    Thinking of installing a Norac UC3 tillage depth control on our 5710 air drill. Anyone have any thoughts or experience's with this product? Would appreciate your input.
    Tags: None
    • cris
      Senior Member
      • Feb 2000
      • 143
      #2
      never used one before and am wondering why? once ours is set we rarely change it and if you repase every 3 or four rounds it stays very level. It is very important to rephase.

        Comment

        • wd9
          Senior Member
          • Nov 2000
          • 3196
          #3
          agreed. If you want accurate control the thing will be constantly searching for the right depth, it will be right half the time. You will get more consistency just by rephasing and run against blocks. Tried the UC2, it was a disaster. Over the width of the drill, where do you point the sensor to get an accurate depth? Always tradeoffs.

          Get a conservapak or any other independent shank/wheel system for real good accuracy that actually follows the ground.

            Comment

            • Reply to this Thread
            • Return to Topic List
            Working...